Both are right!

When referring to the pins and blocks on the Samtec look at the pin
labels inside the connector blocks on the schematic.

Don't refer to the designator sub letters. These don't match the
connector blocks. The reason for this is that there is an extra block on
the schematic part which holds the mounting lugs (JxxA), hence all the
others are shifted by one.

-----Original Message-----
From: balloon-admin@balloonboard.org
[mailto:balloon-admin@balloonboard.org] On Behalf Of Wookey
Sent: 01 December 2004 17:57
To: Balloon
Subject: [Balloon] Samtek labelling clarification

Glen pointed out that we have inconsistent labelling of the samtek
connector
between the schemeatics:
http://www.balloonboard.org/hardware/205/2.05connector.pdf
and the website:
http://www.balloonboard.org/hardware/205/con/samtek.html

On the schematic the sections are B-F, and above they are A-E. The
datasheet
doesn't have much to say on the matter? Which is right?

The website is a lot easier to change...

Wookey
-- 
Aleph One Ltd, Bottisham, CAMBRIDGE, CB5 9BA, UK  Tel +44 (0) 1223
811679
work: http://www.aleph1.co.uk/     play:
http://www.chaos.org.uk/~wookey/

_______________________________________________
Balloon mailing list
Balloon@balloonboard.org
http://balloonboard.org/mailman/listinfo/balloon