On 2006-10-12 11:08 +0100, David Bisset wrote:
> >Another issue, one of the boards has a solder blob between two
> >components near the rework on the FPGA PSU controller. Another board has
> >a component slewed to touch the one next to it in the same place as the
> >solder-blob. Looking under a magnifier didn't quite convince me that
> >they aren't connected to the same trace anyway, but getting schematics
> >and at least top + bottom layer layouts for the various balloon builds
> >would be of great assistance in determining if these soldering defects
> >are a problem or not.
> 
> If you can send me a photo I'll take a look, if it's a manufacturing fault
> then it needs to go back to be fixed. 

But what about schematics?  This is supposed to be an open design, and
B3 schematics have been unobtainium for months now. Is there some
problem?

Wookey
-- 
Aleph One Ltd, Bottisham, CAMBRIDGE, CB5 9BA, UK  Tel +44 (0) 1223 811679
work: http://www.aleph1.co.uk/                 play: http://wookware.org/