> > -----Original Message-----
> > From: Charles Manning [mailto:manningc2@actrix.gen.nz] 
> > Sent: 01 November 2006 23:09
> > To: yaffs@lists.aleph1.co.uk
> > Cc: Johann Kok (JP)
> > Subject: Re: [Yaffs] delete of chunkId:
> > 
> > On Monday 30 October 2006 20:18, Johann Kok (JP) wrote:
> > Hi,
> > during yaffs init I get the message "delete of chunkId:" with 38
> > different chunkID's.  Then after the init is done and without
doing
> > any yaffs operations I reset the CPU and I get the same 38 
> > "delete of chunkId:" messages again.
> >
> > Isn't this a problem?  Shouldn't it only delete them once?
> >
> > regards
> > Johann Kok


> You don't say whether you're using yaffs2 or yaffs(1).
> 
> If you're using yaffs(1) then this is a problem because it 
> would indicate that 
> attempts to delete a chunk are not "sticking". That would 
> indicate, most 
> likely, some problem in your byte mapping in the nand driver.
> 
> If you're using yaffs2 then this is not a problem. Deletion 
> in yaffs2 does not 
> end up being a physical mark on the nand, but is on a run-time
state. 
> Therefore deletions will be perfomed like this until the 
> block containing the 
> chunk is erased.
> 
> -- CHarles

Hi Charles, 
I use yaffs2, so no problemo. 

Thanks
Johann Kok

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This e-mail and its contents are subject to the Telkom SA Limited
e-mail legal notice available at 
http://www.telkom.co.za/TelkomEMailLegalNotice.PDF
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~