Peter TB Brett wrote: > I'd appreciate it if someone could recommend a FFC connector that's known to > be suitable for interfacing to the Samosa bus on B3. Since I don't actually > have a Balloon around for me to look at when doing my PCB layout, some idea > of where on the board it needs to go would be quite helpful too! Farnell 111-2561 works for me. Although cheap and nasty in some ways, the Omron flip-up connectors like that one can contact the FFC on both top and bottom sides, which is handy when the PCB layout turns out to be back to front. Not that that's ever happened to me, you understand . As for where the connector is, it's J6 on the right hand side of this diagram: http://www.balloonboard.org/hardware/300/Balloon3.0V1_Overlay_Top.pdf It's a top-contact FFC connector and pin 1 is at the bottom, next to U10. HTH Chris -- Chris Jones - chris@martin-jones.com Martin-Jones Technology Ltd, makers of Solidlights 148 Catharine Street, Cambridge, CB1 3AR, UK Phone +44 (0) 1223 655611 Fax +44 (0) 870 112 3908 http://www.solidlights.co.uk/