On Thu, Oct 23, 2008 at 4:29 PM, Rutger Hofman <rutger@cs.vu.nl> wrote:
> [Forwarded from the YAFFS mailing list also to the eCos list]
>
> Currently eCos has no real support for NAND flash. However, at this very
> moment I am working on that -- it is the main part of my job right now.
> Status: my pilot eCos NAND flash layer is working right now on my
> BlackFin, including Bad Block Table, ECC, etc. But before I publish, I
> need lots more stress testing.
>

Interesting, you are porting eCos to Blackfin. What kind of Blackfin
hardware are you using?

-Bryan

> I am also going to run YAFFS2 on this eCos NAND Flash layer. I just
> started making an eCos wrapper for it.
>
> If you would like to join me in stress testing, well, I welcome that.
>
> Rutger Hofman
> VU Amsterdam
>
> Deroo Stijn wrote:
>> Hi,
>>
>> Does someone have some documentation on how to integrate yaffs2 into the eCOS operating system?
>> On the yaffs internet page, I found some documentation about yaffs1, but there isn't any doc describing yaffs2.
>>
>> Kind regards,
>> Stijn Deroo
>>
>>
>>
>>
>> ---
>> Stijn Deroo
>> R&D Engineer
>> Televic Transport Systems
>> http://www.televic.com
>> Televic NV / SA (main office)
>> Leo Bekaertlaan 1
>> B-8870 Izegem
>> Tel: +32 (0)51 303045
>> Fax: +32 (0)51 310670
>>
>> _______________________________________________
>> yaffs mailing list
>> yaffs@lists.aleph1.co.uk
>> http://lists.aleph1.co.uk/cgi-bin/mailman/listinfo/yaffs
>
>
> _______________________________________________
> yaffs mailing list
> yaffs@lists.aleph1.co.uk
> http://lists.aleph1.co.uk/cgi-bin/mailman/listinfo/yaffs
>