Sorry to post this off list, but why didn't you use the RTOS supported by AID? I'm thinking of using a blackfin for our project and just wondering about the RTOS selection... ----- Original Message ---- From: Rutger Hofman To: Deroo Stijn Cc: "yaffs@lists.aleph1.co.uk" ; ecos-discuss@ecos.sourceware.org Sent: Thursday, October 23, 2008 3:29:20 AM Subject: [ECOS] Re: [Yaffs] YAFFS2 in eCOS [Forwarded from the YAFFS mailing list also to the eCos list] Currently eCos has no real support for NAND flash. However, at this very moment I am working on that -- it is the main part of my job right now. Status: my pilot eCos NAND flash layer is working right now on my BlackFin, including Bad Block Table, ECC, etc. But before I publish, I need lots more stress testing. I am also going to run YAFFS2 on this eCos NAND Flash layer. I just started making an eCos wrapper for it. If you would like to join me in stress testing, well, I welcome that. Rutger Hofman VU Amsterdam Deroo Stijn wrote: > Hi, > > Does someone have some documentation on how to integrate yaffs2 into the eCOS operating system? > On the yaffs internet page, I found some documentation about yaffs1, but there isn't any doc describing yaffs2. > > Kind regards, > Stijn Deroo > > > > > --- > Stijn Deroo > R&D Engineer > Televic Transport Systems > http://www.televic.com > Televic NV / SA (main office) > Leo Bekaertlaan 1 > B-8870 Izegem > Tel: +32 (0)51 303045 > Fax: +32 (0)51 310670 > > _______________________________________________ > yaffs mailing list > yaffs@lists.aleph1.co.uk > http://lists.aleph1.co.uk/cgi-bin/mailman/listinfo/yaffs -- Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss