We already has eCos in our project (http://www.rfidguardian.org) on an XScale. We decided to switch to BlackFin mostly because Marvell (the current XScale owner) is mean with providing documentation. Just curious: how is AID's RTOS better than eCos? Rutger (It's still on the list...) Tim michals wrote: > Sorry to post this off list, but why didn't you use the RTOS supported by AID? I'm thinking of using a blackfin for our project and just wondering about the RTOS selection... > > > > ----- Original Message ---- > From: Rutger Hofman > To: Deroo Stijn > Cc: "yaffs@lists.aleph1.co.uk" ; ecos-discuss@ecos.sourceware.org > Sent: Thursday, October 23, 2008 3:29:20 AM > Subject: [ECOS] Re: [Yaffs] YAFFS2 in eCOS > > [Forwarded from the YAFFS mailing list also to the eCos list] > > Currently eCos has no real support for NAND flash. However, at this very > moment I am working on that -- it is the main part of my job right now. > Status: my pilot eCos NAND flash layer is working right now on my > BlackFin, including Bad Block Table, ECC, etc. But before I publish, I > need lots more stress testing. > > I am also going to run YAFFS2 on this eCos NAND Flash layer. I just > started making an eCos wrapper for it. > > If you would like to join me in stress testing, well, I welcome that. > > Rutger Hofman > VU Amsterdam > > Deroo Stijn wrote: >> Hi, >> >> Does someone have some documentation on how to integrate yaffs2 into the eCOS operating system? >> On the yaffs internet page, I found some documentation about yaffs1, but there isn't any doc describing yaffs2. >> >> Kind regards, >> Stijn Deroo >> >> >> >> >> --- >> Stijn Deroo >> R&D Engineer >> Televic Transport Systems >> http://www.televic.com >> Televic NV / SA (main office) >> Leo Bekaertlaan 1 >> B-8870 Izegem >> Tel: +32 (0)51 303045 >> Fax: +32 (0)51 310670 >> >> _______________________________________________ >> yaffs mailing list >> yaffs@lists.aleph1.co.uk >> http://lists.aleph1.co.uk/cgi-bin/mailman/listinfo/yaffs > >