Hi guys, me again.
I think that all of my configurations on yaffs is just fine, so the only
possiblity is that
I'm doing something wrong with the MTD stuff or.. I made a shameful mistake.
(The problem was.. I keep getting the message 'Reading data from NAND FLASH
without ECC is not recommended')
I use my NAND chip partitioned into 5 pieces.
here's a portion of code declaring the partitions.
/*
* Define partitions for flash device
*/
static struct mtd_partition partition_info[] = {
{ name: "Magic Block for idis",
offset: 0,
size: 32 * 512 },
{ name: "Upgrade Image for idis",
offset: 16384,
size: 2 * 1024 * 1024 },
{ name: "Kernel Image for idis",
offset: 2113536,
size: 2 * 1024 * 1024 },
{ name: "Root File System for idis",
offset: 4210688,
size: 11 * 1024 * 1024 },
{ name: "Setup and etc. for idis",
offset: 15745024,
size: 1032192 }
};
#define NUM_PARTITIONS 5
I think I heard someone saying something about 'oobsel', but I don't see
clearly
what I should do.
I, once again must apologize for bothering all the YAFFSers around the
world and
wasting their time. (sniff)
---------------------------------------------------------------------------------------
This mailing list is hosted by Toby Churchill open software (
www.toby-churchill.org).
If mailing list membership is no longer wanted you can remove yourself from the list by
sending an email to
yaffs-request@toby-churchill.org with the text "unsubscribe"
(without the quotes) as the subject.