Re: [Yaffs] Yaffs2 erasure issue on MT29 NAND part

On Thursday 23 July 2009 05:07:19 Andrew McKay wrote:
> Hi,
>
> I'm using YAFFS2 on a Micron 2GB NAND part (MT29F16G08). I'm using kernel
> version 2.6.20.4. I have back ported a patch for 128Bit OOB support at the
> MTD level and things seem to be working fine from that perspective.
> However during bootup I see messages like:
>
> **>> Erasure failed 302
> **>> Block 302 retired
> Block 302 is in state 9 after gc, should be erased
> page 134426 in gc has no object: 0 0 0
> **>> Erasure failed 2100
> **>> Block 2100 retired
> Block 2100 is in state 9 after gc, should be erased
>
> This message repeats every time the board is booted. I would assume that
> if a block is retired it should be listed in the bad block list during boot
> up. This device has a long long list of bad blocks (some of them may have
> gotten that way during development of my NAND driver). Another board we
> are using has less bad blocks but also has messages that it retired a
> block, and yet on next boot it does it again.
>
> Anybody have any hints as to what I should be looking for, or whether this
> is really an issue or not?

It looks like your bad block marking strategy or the erase is not working
properly.

Try doing some nandwrites etc to manually do stuff to the block and see if
that works.

-- Charles