[Yaffs] Re: bit error rates

Top Page
Attachments:
Message as email
+ (text/plain)
Delete this message
Reply to this message
Author: Sergei Sharonov
Date:  
To: yaffs
Subject: [Yaffs] Re: bit error rates
Hi,
> Do you have your write protect pin tied to a power fail flag or such?
> The way the wp pin works is to disable the internal programming voltage
> generator. The residual charge might be enough to complete a write, but
> is not enough to complete an erase.


First I had it tied to the system reset then (per your recomendation) I
reconnected it to the Vcc. Subjectively it helped a bit but the power
cycling problems were still there. I also recall seeing "bit flipping"
phenomenon when a bit would be partially written and then would sometimes
read as 1 and sometimes as 0.

> If wp is not disabled and the system rails can supply sufficient power
> to the NAND chip to complete the erase (~2 to 3 msec) then things should
> be fine.


I have about 2 ms from reset trip point to when Vcc hits 2.7 V (lowest NAND
Vcc spec)


Sergei