Sorry to post this off list, but why didn't you use the RTOS supported by AID? I'm thinking of using a blackfin for our project and just wondering about the RTOS selection...
----- Original Message ----
From: Rutger Hofman <
rutger@cs.vu.nl>
To: Deroo Stijn <
S.Deroo@TELEVIC.com>
Cc: "
yaffs@lists.aleph1.co.uk" <
yaffs@lists.aleph1.co.uk>;
ecos-discuss@ecos.sourceware.org
Sent: Thursday, October 23, 2008 3:29:20 AM
Subject: [ECOS] Re: [Yaffs] YAFFS2 in eCOS
[Forwarded from the YAFFS mailing list also to the eCos list]
Currently eCos has no real support for NAND flash. However, at this very
moment I am working on that -- it is the main part of my job right now.
Status: my pilot eCos NAND flash layer is working right now on my
BlackFin, including Bad Block Table, ECC, etc. But before I publish, I
need lots more stress testing.
I am also going to run YAFFS2 on this eCos NAND Flash layer. I just
started making an eCos wrapper for it.
If you would like to join me in stress testing, well, I welcome that.
Rutger Hofman
VU Amsterdam
Deroo Stijn wrote:
> Hi,
>
> Does someone have some documentation on how to integrate yaffs2 into the eCOS operating system?
> On the yaffs internet page, I found some documentation about yaffs1, but there isn't any doc describing yaffs2.
>
> Kind regards,
> Stijn Deroo
>
>
>
>
> ---
> Stijn Deroo
> R&D Engineer
> Televic Transport Systems
> http://www.televic.com
> Televic NV / SA (main office)
> Leo Bekaertlaan 1
> B-8870 Izegem
> Tel: +32 (0)51 303045
> Fax: +32 (0)51 310670
>
> _______________________________________________
> yaffs mailing list
> yaffs@lists.aleph1.co.uk
> http://lists.aleph1.co.uk/cgi-bin/mailman/listinfo/yaffs
--
Before posting, please read the FAQ:
http://ecos.sourceware.org/fom/ecos
and search the list archive:
http://ecos.sourceware.org/ml/ecos-discuss