[Forwarded from the YAFFS mailing list also to the eCos list]
Currently eCos has no real support for NAND flash. However, at this very
moment I am working on that -- it is the main part of my job right now.
Status: my pilot eCos NAND flash layer is working right now on my
BlackFin, including Bad Block Table, ECC, etc. But before I publish, I
need lots more stress testing.
I am also going to run YAFFS2 on this eCos NAND Flash layer. I just
started making an eCos wrapper for it.
If you would like to join me in stress testing, well, I welcome that.
Rutger Hofman
VU Amsterdam
Deroo Stijn wrote:
> Hi,
>
> Does someone have some documentation on how to integrate yaffs2 into the eCOS operating system?
> On the yaffs internet page, I found some documentation about yaffs1, but there isn't any doc describing yaffs2.
>
> Kind regards,
> Stijn Deroo
>
>
>
>
> ---
> Stijn Deroo
> R&D Engineer
> Televic Transport Systems
> http://www.televic.com
> Televic NV / SA (main office)
> Leo Bekaertlaan 1
> B-8870 Izegem
> Tel: +32 (0)51 303045
> Fax: +32 (0)51 310670
>
> _______________________________________________
> yaffs mailing list
> yaffs@lists.aleph1.co.uk
> http://lists.aleph1.co.uk/cgi-bin/mailman/listinfo/yaffs
(text/plain)